Proxmark3 community
Research, development and trades concerning the powerful Proxmark3 device.
Remember; sharing is caring. Bring something back to the community.
"Learn the tools of the trade the hard way." +Fravia
You are not logged in.
Announcement
Time changes and with it the technology
Proxmark3 @ discord
Users of this forum, please be aware that information stored on this site is not private.
Pages: 1
#1 2021-12-24 02:10:00
- kosgguy
- Contributor
- Registered: 2021-12-18
- Posts: 56
[question] iceman standalone mode
I have a doubt in standalone mode, after doing hw status, my installed standalone mode is
[#] Installed StandAlone Mode
[#] HF iCLASS mode - aka iceCLASS (iceman)
But when I execute the standalone mode, I get the following
[#] Stand-alone mode, no computer necessary
[#] HF iCLASS mode a.k.a iceCLASS started
[#] -=[ enter `full simulation` mode ]=-
[#] error iceclass-orig.bin file missing
[#] -=[ exit ]=-
and I don't know what to do. Any ideas?
Offline
#2 2021-12-24 12:56:38
- iceman
- Administrator
- Registered: 2013-04-25
- Posts: 9,537
- Website
Re: [question] iceman standalone mode
Omikron and I did a talk where it is mentioned. https://www.youtube.com/watch?v=ghiHXK4GEzE
Its not clear, but if you read the output, full simulation and it says its missing a file, would indicate you would need to have a file of a tag that you want to use for simulation.
Anyway, this standalone mode is more for the advanced proxmark3 users.
Offline
#3 2021-12-24 13:46:24
- kosgguy
- Contributor
- Registered: 2021-12-18
- Posts: 56
Re: [question] iceman standalone mode
ohh awesome. I will look the video. I have also realized you have another video also in youtube, you talking about proxmark, I have watched a little bit too.
So there is a file missing. I will look into that.
Thanks
Offline
Pages: 1