Proxmark3 community
Research, development and trades concerning the powerful Proxmark3 device.
Remember; sharing is caring. Bring something back to the community.
"Learn the tools of the trade the hard way." +Fravia
You are not logged in.
Announcement
Time changes and with it the technology
Proxmark3 @ discord
Users of this forum, please be aware that information stored on this site is not private.
#1 2019-03-27 00:15:28
- cosmic
- Contributor
- Registered: 2019-03-18
- Posts: 6
Run lua script upon proxmark boot or button held
Is there a way to have the proxmark firmware start running a lua script on boot.
Let's say I created a lua script that continuously wrote a certain ID to a tag.
Assuming I included this script in the firmware and added it into the code base, how could i be sure it runs right away when plugged into a battery and not a computer.
With or without the press of a button?
Offline
#2 2019-03-27 05:22:25
- iceman
- Administrator
- Registered: 2013-04-25
- Posts: 9,538
- Website
Re: Run lua script upon proxmark boot or button held
Never seen lua scripts running in standalone mode. I don't think the lua scripting engine is included in the firmware. Don't think it will fit.
Normally you write your own standalone mode in C and since you want to have it to run all the time without buttonpress you will need to just run it. If you look at armsrc/Appmain.c , way in the bottom you see where you can have your code running in the main loop.
Offline