Research, development and trades concerning the powerful Proxmark3 device.
Remember; sharing is caring. Bring something back to the community.
"Learn the tools of the trade the hard way." +Fravia
You are not logged in.
Time changes and with it the technology
Proxmark3 @ discord
Users of this forum, please be aware that information stored on this site is not private.
I have been messing around with the lf em 410xread command and was wondering if I could get the scanned UIDs when I plug it back it in.
Is there a way to read a UID em410x card on battery power and re-call it from the memory when you plug it in to the computer?
Offline
No. Scan memory is lost when powered down.
Offline
No. Scan memory is lost when powered down.
How would can I get the scan memory if I dont power it down?
Thanks for your time,
Nate
Last edited by natezoom (2017-11-23 03:54:39)
Offline
on some pm3 hardware and the current firmware this cannot be done at this time.
i heard somewhere someone was working on being able to plug in a rv2 pm3 on battery to a computer without resetting it. but i'm not aware of their results.
as an alternative
there is a standalone mode for em410x that i believe can clone an em id to a t55x7. but firmware has to be changed & flashed to turn it on.
or use a tablet/laptop or one of the phone clients and have it plugged in the whole time...
Offline
on some pm3 hardware and the current firmware this cannot be done at this time.
i heard somewhere someone was working on being able to plug in a rv2 pm3 on battery to a computer without resetting it. but i'm not aware of their results.
as an alternative
there is a standalone mode for em410x that i believe can clone an em id to a t55x7. but firmware has to be changed & flashed to turn it on.
or use a tablet/laptop or one of the phone clients and have it plugged in the whole time...
Where can I find that firmware? i thought it could only clone HID badges
thanks,
Nate
Offline
hello?
Offline
natezoom, you can get the latest source from github, which includes the firmware. After that you can change/add the standalone mode you need and then re-compile & flash it on your pm3.
Offline