Proxmark3 community

Navster

Contributor

Registered: 2017-07-09

Posts: 50

Proxmark3 easy

After updating the firmware on the Proxmark I have led A and B on. Mac doesn’t recognize the Proxmark. LEDs won’t go off and I can’t use the device as stand alone anymore. Does this mean it’s bricked? If so how does one de-brick. Proxmark was working fine before the update.
Thanks in advance!!

Dot.Com

Contributor

From: Hong Kong

Registered: 2016-10-05

Posts: 180

Website

Re: Proxmark3 easy

Even though this is not the trend to post your problems. I will kindly solve it for now.

When flashing, hold on the button for pm3. For the pm3 easy, we always get this bug.

When hold on to the button the LED will go off. Let the port detect the proxmark3.

Once detected, flash it. Once, the pm3 will be un-brick.

Navster

Contributor

Registered: 2017-07-09

Posts: 50

Re: Proxmark3 easy

Thanks Dot! I realized I had to hold the button for the mac to detect the pm3. However the bootrom was a CDC(originally) and now shows up as HID. I tried to flash the bottom holding the button down but it just hangs at wainting for proxmark USB..............

Loading usable ELF segments:
0: V 0x00100000 P 0x00100000 (0x00000200->0x00000200) [R X] @0x94
1: V 0x00200000 P 0x00100200 (0x00000cc8->0x00000cc8) [R X] @0x298

Waiting for Proxmark to appear on /dev/tty.usbmodem1421.....................................................................................................................................................

I've tried hold ing the button down and without. I had reinstalled proxmark 3 through homebrew. Now the mac can't seem to detect the port??  I've installed mac ports btw.

Last edited by Navster (2017-07-12 03:56:10)