Proxmark3 community
Research, development and trades concerning the powerful Proxmark3 device.
Remember; sharing is caring. Bring something back to the community.
"Learn the tools of the trade the hard way." +Fravia
You are not logged in.
Announcement
Time changes and with it the technology
Proxmark3 @ discord
Users of this forum, please be aware that information stored on this site is not private.
#1 2010-02-19 21:40:32
- Omikron
- Contributor
- Registered: 2010-02-12
- Posts: 78
Flashing with J-Flash and Atmel SAM-ICE
I'm currently trying to flash a blank board with Segger's J-Flash utility, but I'm not having much luck. I can erase and flash the target with the basic ebuller image, but the board still behaves as if it's blank, with all LED's staying lit when powered on.
I speculate that this may be due to the flashing settings that I'm using, but I'm not sure what to change first.
Here are the current project settings I am using:
As I mentioned, these settings currently appear to "work" and J-Flash reports success, but the board's behavior does not change. All LED's are on and stay on.
Does anyone have any thoughts on what I should change to get things rolling?
Offline
#2 2010-02-19 21:53:25
- Omikron
- Contributor
- Registered: 2010-02-12
- Posts: 78
Re: Flashing with J-Flash and Atmel SAM-ICE
I suppose this should have gone in the "Questions and Requests" forum. An admin/mod can move it as deemed necessary.
Offline
#3 2010-02-19 21:56:48
- d18c7db
- Contributor
- Registered: 2008-08-19
- Posts: 292
Re: Flashing with J-Flash and Atmel SAM-ICE
Just for a gag, in the second screen, JTAG speed after init, limit that to no more than 200KHz and try again.
Offline
#4 2010-02-19 22:26:36
- Omikron
- Contributor
- Registered: 2010-02-12
- Posts: 78
Re: Flashing with J-Flash and Atmel SAM-ICE
Just for a gag, in the second screen, JTAG speed after init, limit that to no more than 200KHz and try again.
I went ahead and set "JTAG speed after init" to 200kHz. As before, J-Flash reports success on program and verify but no observed effect on PM3.
Offline