Research, development and trades concerning the powerful Proxmark3 device.
Remember; sharing is caring. Bring something back to the community.
"Learn the tools of the trade the hard way." +Fravia
You are not logged in.
Time changes and with it the technology
Proxmark3 @ discord
Users of this forum, please be aware that information stored on this site is not private.
We have just received a Proxmark3.
From the documentation it says that we need to upgrade the flash to support Type A.
I have downloaded pm3-20090905-r216.
From the cockpit directory I have run the batch file 4flashos.bat. Before running this I held the button down and then plugged the Proxmark3 unit into the USB port.
I get the following output and would appreciate it if someone would tell me what I am doing wrong. It also recommends that I must update the bootloader. How do I do this?
I have also tried running 0setpath.bat before I do anything but it doesn't help.
H:\Projects\Proxmark\Downloads\pm3-20090905-r216\pm3-20090905-r216\cockpit>4flashos.bat
********************************************************************
* REMEMBER: hold button down for the duration of the FLASH process *
********************************************************************
Warning: area name 'load' unknown, ignored
Warning: area name 'load' unknown, ignored
Flashing fpga from ..\armsrc\obj\fpgaimage.s19
Warning: Your bootloader does not understand the new START_FLASH command
It is recommended that you update your bootloader
Flashing address: 0000c400
done.
Offline
Have you read my post: Help - #db# unknown command - loread - by jaeger.
Does this help?
kind regards,
JaEGeR.
Offline
Ah, apparently that batch file still had the commands for the old flash tool and was only updated in revision 230. Please enter the flash command manually, as detailed in http://code.google.com/p/proxmark3/wiki … _the_board
Last edited by henryk (2009-10-12 13:05:42)
Offline