Research, development and trades concerning the powerful Proxmark3 device.
Remember; sharing is caring. Bring something back to the community.
"Learn the tools of the trade the hard way." +Fravia
You are not logged in.
Time changes and with it the technology
Proxmark3 @ discord
Users of this forum, please be aware that information stored on this site is not private.
ne4rab it seems that only you work most with the Q5 would you pls have a look to see my result is right.
Thanks
Last edited by ntk (2015-06-09 22:42:36)
Offline
for practical work, if I take the example we had recently on T55x7
Data bitrate = RF/32
Modulation = Direct
Maxblk = 4
the configuration block on G5 will be
bit1 to bit12 master = '00000000000'
bit13 page select = 0
bit 14 fast write = 0
bit 15 to bit 20 data bit rate RF/(2n+2) with n0 to n5???!!! our case is RF/32 so would be "001111"
bit 21 AOR, I have no idea so I set = 0,
bit 22 use password, none so = 0
bit23 to 24 PSK carrier freq would be rf/2 = '00'
bit25 inverse data output
bit 26 to 28 modulation type, if for direct modulation so set to '111'
bit 29 to 31 if we have 4 data blocks to send, then I set them to '100'
bi32 Sequence terminator ST, I knew from previous experience this bit has some importance when bit 25 is set to 1, but what logic tell me to set this bit to 0 or 1? I set this to 0
I would say for the example nz/32, 4 blocks datas my configuration block would be
01100000000 0 0 001111 0 0 00 0 111 100 0
and that is in hex
3000F078
or
00000000000 0 0 001111 0 0 00 0 111 100 0
and in hex
0000F078
I am till not sure about the first 4 bits. what is the effect when the test bits =6 are set?
Last edited by ntk (2015-06-09 22:37:11)
Offline