Research, development and trades concerning the powerful Proxmark3 device.
Remember; sharing is caring. Bring something back to the community.
"Learn the tools of the trade the hard way." +Fravia
You are not logged in.
Time changes and with it the technology
Proxmark3 @ discord
Users of this forum, please be aware that information stored on this site is not private.
Hi,
I am currently working on my ProxMark and tried to modify the ARM source.
My last flashing certainly went wrong since then, i can't manage to connect to my ProxMark using USB. The device starts , the 3 leds are on during almost 10 seconds, then it reboots.
All my USB flashing attempts (using "official" firmware versions) led me to nothing.
I decided to build a Wiggler JTAG cable as shown in the documentation (in the http://www.proxmark.org/files/index.php … -linux.zip file). I checked it, plugged it in the computer, using Debian operating system, and ran the flash program.
At that time, the USB port was powered as required by the SAM7X256-16-to-48Mhz application.
But whatever I do, I still get the message "unable to stop target".
An another hand, I noticed that the USB port was hotter when the JTAG cable was plugged. Is this normal ?
Do you guys have any clue about what I can do to make my device work again ?
Thank you very much for your time.
Last edited by ereon (2009-07-09 08:12:14)
Offline
ereon, when I get my JTAG cable, I'll see if I can help. Patiently waiting for now.
Last edited by samy (2009-07-20 06:54:04)
Offline