Proxmark3 community

bestcarsauto

Contributor

Registered: 2019-06-21

Posts: 12

Hello, I just bought a Proxmark3 RDV4

Hi
I just bought a Proxmark3 RDV4 without knowing anything about RFID hoping to learn a little about this fascinating tool. I already start looking for videos and all info that I can find in the internet and I can see that its a lot of information but most of this info is for the old units and is not too much about the Proxmark3 RDV4 anyway hope in this forum get the help that I need.
When I saw some videos gave me the impression that as soon I get the machine I can be  cloning some tags and Id cards but that was no possible because the unit even though following the instructions using a power supply the machine does not recognize the pieces that I want to clone not even the cards that came with it, at this point I'm not sure if is the unit itself that is defective or if I'm doing something wrong, then I try to install it in the computer and followed the instructions (https://www.youtube.com/watch?v=zzF0NCMJnYU&feature=youtu.be) and at the end I get a message: "Unknow+User@DESKTOP-4G3DULf MING64 ~" so I'm stuck because I can not find anything about the problem.
Any advice will be appreciated.
Thanks

iceman

Administrator

Registered: 2013-04-25

Posts: 9,537

Website

Re: Hello, I just bought a Proxmark3 RDV4

Welcome and I suggest you read http://www.proxmark.org/forum/viewtopic.php?id=1125 as an introduction.

Your access rights has been updated.