Proxmark3 community

Boof_rob

Contributor

From: Inverell, NSW

Registered: 2018-03-27

Posts: 14

Hi All

Hi everyone,

I am new to this forum. Thanks in advance for any assistance.
Have Just received a proxmark 3 from China. Plugged it in to my Windows 7 64bit computer. windows unable to install any drivers fir the unit, and when I look in Device manager, it is sitting in the "Unknown Device" area. Tried to manually update driver, but get a message "Windows was unable to install Unknown Device".
Downloaded 20180322
Love some help to the first hurdle.

Cheers
Robert

iceman

Administrator

Registered: 2013-04-25

Posts: 9,537

Website

Re: Hi All

Welcome and I suggest you read http://www.proxmark.org/forum/viewtopic.php?id=1125 as an introduction.

Boof_rob

Contributor

From: Inverell, NSW

Registered: 2018-03-27

Posts: 14

Re: Hi All

Welcome and I suggest you read http://www.proxmark.org/forum/viewtopic.php?id=1125 as an introduction.

Ok.

Was able to to do all, got to "make clean" (all good), then when I did "make all", got some of the way, then I got
"proxguiqt.h:17:24: fatal error: QApplication: No such file or directory
compliation terminated.
make[1]: ***[pbj/proxgui.o] Error 1
maker[1]: Leaving directory 'pm3/client'
make: ***[client/all Error 2"

But still say unknown device when I plug the unit into my computer, nothing in the HID area.

Cheers

Robert

iceman

Administrator

Registered: 2013-04-25

Posts: 9,537

Website

Re: Hi All

This is the introduction. 
please, post in the correct section.