Research, development and trades concerning the powerful Proxmark3 device.
Remember; sharing is caring. Bring something back to the community.
"Learn the tools of the trade the hard way." +Fravia
You are not logged in.
Time changes and with it the technology
Proxmark3 @ discord
Users of this forum, please be aware that information stored on this site is not private.
Pages: 1
Hi guys, I have this tag sub-model explained at page10 [AT88RF04C]; the tag is 1x1 cm and it is not seen by my proxmark antenna... my doubt is: can the tag "smallnes" create problems with a "big" pm3 antenna causing it not to be read ? I tested every possible position...
Offline
I try to reply at your question. For small RFID I created a small antenna 2 cm diameter and 6 turns. The wire enamelled is about 1 mm diameter. I maked many tests before to reach a good voltage with hw tune about 11V. I can ensure it's work with a little tag SRIX4K.
Offline
Jonor you are right, that small antenna works GREAT with small tags! Thank you man !!!
Last edited by asper (2013-09-12 09:09:55)
Offline
Pages: 1